What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
08.06.2025 09:11

One is “what exactly is in a ‘surge protector’ ? ”
The other is “what does a “fuse” do?”
Upvotes:
What is the dirtiest thing you have allowed your husband to do?
The third is lightning and “how it gets conducted into a home.”
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
Because the load is inductive, the current lags the voltage.(by a bit).
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
He then describes Rainy Season and Lightning.
Inside ‘Inside the NBA’ Transition to ESPN - Front Office Sports
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
Why does the God of the Bible condemn homosexual acts?
But it can get overloaded, and no longer works.
What does a fuse do?
This device then solves the entire problem.
Why do untreated borderlines always blame their partners when they actually think they are normal?
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
Now when you have a certain ac resistance, then a current flows in a loop.
This is where the MOV conducts again, and dissipated the energy.
What are my 10 favorite rock record album opening tracks?
the problem then depends on "how fast does the fuse operate?".
Edit 2024–10.
First Sentence:
What was your most memorable combat mission during the Vietnam War?
eight
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
The bolt then partially travels down the line to your home.
So THAT'S Why Mosquitoes Bite Some People More Than Others - BuzzFeed
An AC voltage/ current source, and an ac inductive load.
He then describes the function of a fuse.
It also is a device that limits the change in current flow.
a photo is worth a thousand words.
[old diagram got deleted by accident]
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
It seems Mohan does not understand the difference between a comment and an Answer.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
These devices are installed between the “hot” and “neutral” and protective ground.
49ers trade a 2026 conditional fifth-round pick for Bryce Huff - NBC Sports
In schematic diagrams this is the symbol for a fuse:
At one ohm, the resistor has a maximum of 1 watt power.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
I post the exact comment here.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
The MOV will conduct when the voltage exceeds 50% of line voltage.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
One
A circuit breaker is similar, but is resettable.
This one hit behind the barn.
A fuse is a non-resetable over current circuit protector.
2024–10–10[John johnson John Johnson ]
What is lightning?
This is where this question deviates from being a 'generic' question, and becomes more specific.
There are two important concepts here.
But… the neutral is now “floating” because of the 1 ohm resistance.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
what exactly is a ‘surge’ protector?
He then asserts :
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
At least they know the answer if they wanted it.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
Can the fuse protect the electronic devices from lightning instead of a surge protector.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
but I think this circuit , shows a few more pieces.
but this device (an Inductor) … impedes the rapid changes in the current.
2024–10–16 [ OO OLAOYE OYEBODE ]
This is 'the assistant's answer'
so, what happens?
(Dc diagram shown, AC is similar).
This is the picture of an electronic coil of wire wound around a core of magnetic material.
These are simplified answers to the original question, and does not change anything I wrote above.
There are three different concepts here that are getting confused.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
nine
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
[image of Common-mode choke]
Here is a simplified AC power diagram.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
2024–10–14 [Omar Gharbi Omar Gharbi ]
Barnstars:
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
So, the voltage could go up to 500 volts, and the fuse will not open up.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
For this case there are devices called Metal oxide varistors (MOV).